Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
5.2
REPLACE THE CYLINDER
Figure 8
Use only approved replacement cylinder.
Wear heavy gloves or wind cloth around the cylinder when
you touch the cylinder.
1. Stop the machine.
2. Make sure that the cylinder fully stops.
3. Remove the safety key and battery pack.
4. Turn over the machine.
5. Push the slide button as indicated by the arrow.
6. Open up the lock handle.
7. Push the cylinder to the direction of the housing, to lose
the other end of the cylinder.
8. Remove the cylinder.
9. Place a new cylinder into the holder under the housing.
Make sure the bearing shell is positioned with the long
side facing upward.
10. Properly engage the hexagon end of the bearing with the
holder and push in the cylinder.
11. Lock down the lock handle and push back the slide button
to secure the cylinder.
5.3
STORE THE MACHINE
•
Remove the safety key.
•
Remove the battery pack(s).
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
CAUTION
CAUTION
WARNING
WARNING
English
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
6
TROUBLESHOOTING
PROBLEM
Abnormal noise.
Engine perform-
ance drops.
Imprecise scarify-
ing/ dethatching
result.
Motor will not
start.
6
POSSIBLE
SOLUTION
CAUSE
Foreign objects on
Switch off the de-
the cylinder are
thatcher/scarifier,
hitting the de-
wait until the cyl-
thatcher/scarifier.
inder has stopped
rotating. Remove
the foreign ob-
jects.
Soil is too firm.
Adjust working
depth.
Housing clogged.
Clean housing.
Cylinder badly
Replace the cylin-
worn.
der.
Cylinder worn.
Replace the cylin-
der.
Wrong working
Adjust working
depth.
depth.
Battery is not se-
Ensure that the
cure.
battery is fully se-
cured in the ma-
chine. Refer to In-
stall the Battery
section in this
manual.
Battery is not
Charge the battery
charged.
pack according to
the instructions in-
cluded with your
model.
Safety key is not
Insert the safety
in place.
key.
Publicidad
