Publicidad
Idiomas disponibles
Idiomas disponibles
4. With second person, stand previously assembled
uprights and base brackets.
5. Install base fronts, bottom rail and center rail.
(See Figure 6)
IMPORTANT! Do not let framework stand alone
until a back panel is in place. Center rails must
be used.
NOTE: Slide base front into base bracket front
from top or drive in from front. (See Figure 6)
NOTE: Insert tabs on center and bottom rails
into corresponding slots on uprights to install.
NOTE: Ensure rails are installed at same height
on each upright.
Figure 6
Center
Rail
Bottom
Rail
PAGE 5 OF 23
ASSEMBLY CONTINUED
Base Front
BACK PANEL
NOTE: Tops of pegboard backs are marked
with a paint stripe.
NOTE: For two-piece backs, skip to page 6.
ONE-PIECE BACK INSTALLATION
From top of uprights, slide back panel into frame.
(See Figure 7)
NOTE: If ceiling height is not adequate to drop
panels from top, insert one side edge and flex
panel until other edge fits in place.
(See Figure 8)
Figure 7
IMPORTANT! Bend rail tab on opposite side
from panel outward. (See Figure 9)
Figure 9
Rail Tab
Figure 8
0224 IH-4441
Publicidad
