Lincoln Electric SAF-FRO DIGISTEP 355S Manual De Instrucciones página 12

Output Connections
Refer to point [2], [3], [4] and [5] of the Figure 2.
Controls and Operational Features
1. Power Switch ON/OFF (I/O): Controls the input
power to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I"). After input power is connected and the
power switch is turned on, the indicator will light up to
indicate the machine is ready to weld.
2. High Inductance Negative Output Socket: For
the work lead connection.
Low Inductance Negative Output Socket: For
3.
the work lead connection.
4. Wire Feeder Receptacle: 14-pins receptacle for wire
feeder. Provides connections for auxiliary power of
wire feeder.
5. Positive Output Socket: For the source/wire feeder
cable connection.
6. Welding Load Voltage Switch: Adjust the welding
load voltage.
7. Wire Feeder Voltmeter Switch: This switch selects
the polarity of the wire feeder voltmeter, if so
equipped. When the welding torch is positive (MIG,
Outershield and some Innershield processes), set
the switch to "+". When the welding torch is negative
(most Innershield applications), set the switch to "-".
DIGISTEP 355S, 425S, 505S
Figure 2.
English
8. Fuse: Use slow-blow fuse:
355S
3A
9. Power Lead (5m): Connect the supply plug to the
existing input cable that is rated for the machine as
indicated in this manual, and conforms to all
applicable standards. This connection shall be
performed only by a qualified person.
10. Cooler Power Supply Socket: For supplying the
cooler unit only.
The socket has an output of 230V, 2.5A and is protected
by the circuit breaker [11].
11. Circuit Breaker: Protects the Cooler Power Supply
socket. It shuts off the power supply when the
current exceeds 2.5A. Press it to restore the power
supply.
12. Hole Plug: For CO
"Accessories" chapter - K14009-1 CO
Connection Kit).
DIGISTEP 355S,425S,505S
8
DIGISTEP
425S 505S
3A 3A
WARNING
gas heater socket (see
2
2
Figure 3.
Heater
English