Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Bar and chain running hot
and smoking.
Motor runs, but chain is not
rotating.
This product has a Five-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com
TROUBLESHOOTING
CAUSE
Check chain tension for over tight
condition.
Chain oil tank empty.
Oiler is not functioning.
Chain brake is engaged.
Chain tension too tight.
Check guide bar and chain assembly.
Check guide bar and chain for damage.
For any questions about operating or maintaining
your product, call the RYOBI Help Line!
Your product has been fully tested prior to shipment to ensure your
or call (toll free) 1-800-525-2579.
19 - English
SOLUTION
Tension chain. Refer to Chain Tension ear-
lier in this manual.
Check oil tank.
Run at half throttle 30 to 45 seconds. Stop
saw and check for lubricant dripping from
the guide bar. If lubricant is present, the
chain may be dull or bar may be damaged.
If no lubricant is on the guide bar, contact a
qualified service center.
Release chain brake. Refer to Operating
the Chain Brake in the Operation section
of this manual.
Retension chain, Refer to Adjusting Chain
Tension earlier in this manual.
Refer to Replacing the Bar and Chain
earlier in this manual.
Inspect guide bar and chain for damage.
CALL US FIRST
complete satisfaction.
Publicidad
