cosori CAF-R901-AEU Manual De Instrucciones página 8

EN
Air Frying with One Basket (cont.):
• If you do not tap
will automatically change temperature.
c. Tap SHAKE to add/remove a Shake
Reminder.
d. Tap PREHEAT to add/remove Preheat.
5. Tap
to begin air frying.
6. If Preheat is selected, the air fryer will
beep 3 times and show
when preheating is finished. Add food to
the basket.
7. If you added a Shake Reminder, it will
appear halfway through cooking time.
The air fryer will beep 5 times, and
will blink on the display.
a. Take the basket out of the air fryer, being
careful of hot steam. The air fryer will pause
cooking automatically, and the display will
turn off until the basket is replaced.
b. Shake or flip the food.
c. Put the basket back into the air fryer.
Note: See Shaking Food (page 10).
8. During cooking, tap
the cooking light and monitor the
cooking status of the food. The light will
automatically turn off after 2 minutes.
9. The air fryer will beep 3 times when
finished. The display will show "End".
10. Take the basket out of the air fryer, being
careful of hot steam. Use tongs or heat-safe
utensils to remove food from the basket.
CAUTION: The hot crisper plate may fall out
when turning the basket over.
a. Make sure the basket is resting on a
flat surface.
b. Watch for hot oil or fat collected in the
basket. To avoid splashing, drain oil
before replacing the basket. [Figure 6]
11. Allow to cool before cleaning.
8
, then tapping + or —
"Add Food"
to turn on
Air Frying with Two Baskets
Use your air fryer with two baskets to cook
different foods at the same time. The left and
right baskets can be controlled independently
from one another.
1. Place the crisper plates into the baskets.
The crisper plate allows excess oil to drip
down to the bottom of the basket.
Note: The crisper plate may not be used for all recipes,
such as for muffins and breads.
2. Tap
. The left basket is automatically
selected.
3. Select a cooking function (see page 6).
Note: Cooking functions are programmed with an
ideal time and temperature for cooking certain foods.
You can also set a custom time and temperature
without choosing a function.
4. Optionally, adjust the temperature and
time, add/remove Preheat, and add/
remove a Shake Reminder. You can do
this anytime during cooking.
a. Tap to change temperature or
time. The temperature or time will
blink on the display.
b. Tap the + or — buttons to change the
temperature or time.
Note:
• To rapidly increase or decrease time or
temperature, press and hold the + or — buttons.
• If you do not tap
will automatically change temperature.
, then tapping + or —