Installing The Geared Motor - Aprimatic BUONGIORNO Instrucciones Para La Instalación

4
I n s t a l l a t i o n

4.1.1 Installing the geared motor

According to the type of shutter, the following brackets
can be assembled to the geared motor (1):
≠ curved brackets (standard supplied);
articulated brackets (upon request).
• When using the curved bracket (2), assemble it with
the relevant sliding block (4) using the hexagonal head
screw M6x20 (5).
Information
The sliding block (4) shall rotate without efforts; it is
recommended to tighten screw (5), then loosen it by
1/4 turn.
Caution
Pay particular attention to the orientation of rings (6),
(7) and the rotation direction of the bracket (right or
left).
Information
Do not tighten the clutch screws (8); this enables you
further adjustments. Tighten the screws only at the
end of the installation.
• Close the shutter wings.
• Assemble the geared motors to the supporting rail
using the hexagon socket screws M5x80 (10). Pay
special attention to the orientation of the geared
motors. It shall be as shown in the figure.
Information
Do not tighten the locking screws (10) to allow the
geared motors to slide along the guides.
Single-wing
O U
T S
I D
E
I N
S I D
E
- 34 -
1
6
2
3
7
9
Curved brackets
5
4
2
10
Double-wing
8
Articulated brackets
3
10
O U
T S
I D
E
I N
S I D
E
R