Publicidad
Idiomas disponibles
Idiomas disponibles
Problems and possible causes
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank.
• You have been using the burst of
steam button too often.
• Steam is used before the iron is
hot enough.
• The iron is stored with water in the
tank.
• The problem persists.
Your iron produces little or no steam
Water is dripping from the holes in the soleplate
Subject to modifications
Set the temperature control to •••
Switch the steam control to ON.
Fill the water tank.
Wait a few seconds between each burst.
Set the thermostat within the
colored steam zone and wait until
the iron is hot (approx. 2 min.)
Empty the tank before storing the
iron and set the steam control to OFF.
Take your iron to an Approved
Service Center.
9
Solutions
Publicidad
