Publicidad
Idiomas disponibles
Idiomas disponibles
■
Ensure the isolator key is removed before inserting
battery pack.
■
A battery pack must be recharged only with the charger
specified by the manufacturer. Using a charger with an
incompatible battery pack may create a risk of fire. Use
battery pack only with charger listed.
■
Use only battery pack intended specifically for the
product. Use of any other battery packs may result in a
risk of fire, electric shock, or injury to persons.
■
When the battery pack is not in use, keep it away from
other metal objects like, paper clips, coins, keys, nails,
screws, or other small metal objects, that can make a
connection from one terminal to another. Shorting the
battery pack terminals together may cause sparks,
burns, fire or explosion.
■
Do not place battery products or their batteries near
fire or heat. This increases the risk of explosion and
possibly injury.
■
Do not open or mutilate the battery pack. Released
electrolyte is corrosive and may cause damage to the
eyes or skin. It may be toxic if swallowed.
■
Protect the battery pack against moisture and water.
Do not charge the product in a damp or wet location.
Following this rule will reduce the risk of electric shock.
■
In case of damage and improper use of the battery,
vapour may be emitted. Provide for fresh air and seek
medical help in case of complaints. The vapour can
irritate the respiratory system.
■
Do not leave the battery pack inside a vehicle in hot or
cold conditions.
■
Do not incinerate the battery.
■
Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally occurs,
flush with water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the battery may
cause irritation or burns.
SCARIFIER AND AERATOR SAFETY WARNINGS
■
The tines on the product are sharp. Use extreme
caution and wear heavy-duty gloves when fitting,
replacing, cleaning, or checking bolt security.
■
Check that all screws, nuts, bolts, and other fasteners
are properly secured and that guards and screens are
in place. Replace damaged or unreadable labels.
■
Replace worn or damaged parts before operating the
product.
■
Install the debris collector before scarifying. Empty
the debris collector when it is full and reinstall before
resuming operation.
■
The product must be started with the user behind the
handlebars in the operator safety zone. Never start the
product if:
●
not all four wheels are on the ground
●
the debris discharge chute is exposed and is
not protected by the debris collector and debris
discharge chute cover.
■
Never operate the product if the on/off switch on the
handlebar does not properly start and stop the product.
2
| English
■
Never lock the on/off switches in the on position; this is
extremely dangerous.
■
Do not force the product. It will do the job better and
safer at the speed for which it was designed.
■
Stop the tines when crossing gravel surfaces.
■
Use extreme caution when reversing or pulling the
product towards you.
■
Stop the tines if the product has to be tilted for
transportation when crossing surfaces other than grass,
and when transporting the product to and from the work
area.
■
Never use the product with defective guards or shields,
or without safety devices, for example, deflectors and/
or debris collectors, in place.
■
Do not tilt the product when turning on the motor, except
if the machine has to be tilted for starting. If absolutely
necessary, you may lift only the part that is away from
the operator. Always ensure that both hands are in the
operating position before returning the machine to the
ground.
■
Turn on the product carefully according to the
instructions, and keep hands and feet away from the
tines. Do not put hands or feet near or under rotating
parts. Keep clear of the discharge opening at all times.
■
Never pick up or carry the product while it is running.
■
Turn off the product, and disconnect it from the power
supply. Make sure that all moving parts have come to
a complete stop:
●
whenever leaving the product unattended (including
disposal of grass clippings).
●
before cleaning a blockage or unclogging the
discharge chute
●
before checking, cleaning or working on the product
●
after striking a foreign object; inspect the product
for damage and make repairs as necessary before
restarting and operating the product.
■
If the product starts to vibrate abnormally, check
immediately to:
●
inspect for damage
●
replace or repair any damaged parts
●
check for and tighten any loose parts
■
Avoid holes, ruts, bumps, rocks, property stakes, or
other hidden objects. Uneven terrain could cause a
slip-and-fall accident.
■
Release the handle immediately and stay away from
the product if:
●
the product catches fire
●
the guard and/or housing is broken
●
abnormal sound occurs
●
any accident or breakdown occurs
■
Always ensure that the motor control cable is never
trapped, pinched or otherwise damaged during
assembly or when folding the handle.
WARNING
Make sure that the tines are at a complete stop before
removing or installing the debris collector.
Publicidad
