Publicidad
Idiomas disponibles
Idiomas disponibles
Number
Designation
OVER CURRENT PROTECTION
30/31
COMM FATAL ERROR
32
SPEED SENSOR ISSUE
33/35
34
ACC VOLTAGE ERROR
129
DEMO MODE
CELL OVER VOLTAGE
193
195
CELL UNDER VOLTAGE
194
196
CHARGE OVER CURRENT
197
SHORT CUT
199
201
BATTERY IM BALANCE
202
SHORT CUT LOCK
REVERSE CONNECTION
203
CHARGE OVER TEMPERATURE
204
CHARGE UNDER TEMPERATURE
205
DISCHARGE OVER TEMPERATURE
206
DISCHARGE UNDER TEMPERATURE
207
FET OVER TEMPERATURE
208
UNBALANCE CELL
213
Resolution
Current supplied by the Battery Pack is too high. Please reduce the demand.
If the system locks, please restart the eBike System. If the problem persists,
contact your Decathlon workshop.
Fatal Error. restart the eBike system. If the problem persists, contact your
Decathlon workshop.
Speed Sensor error - Motor consumes but Speed not received from sensor.
Check sensor speed. If the problem persists, contact your Decathlon workshop.
Contact your Decathlon workshop.
Contact your Decathlon workshop.
Discharge the battery and then recharge it.
Leave the battery connected to the charger for 2 hours after the charge ends to
balance the cells.
Charge the battery and leave it connected to the charger for 1-2 hours after
the charge ends to balance the cells. If the problem persists, contact your
Decathlon workshop.
Check that the charger is in good condition.
Let the battery rest for 2 hours. If the problem persists, contact your Decathlon
workshop.
Check the charging port. If the problem persists, contact your Decathlon
workshop.
Allow to charge until the error disappears (around 3 hours).
Connect the charger.
Check the charging port and the charger. If the problem persists, contact your
Decathlon workshop.
- Stop charging.
- Allow the system to rest for 30 minutes, with the bicycle turned off.
- Continue charging.
- Stop charging.
- Protect the bicycle from the cold and wait until the temperature of the
cells increases.
- Continue charging.
- Reduce the discharge speed or stop for a few minutes.
- Wait until the temperature drops.
- Avoid large power demands while this error is active to prevent deterio-
ration.
- Charge the battery within the appropriate temperature ranges.
- Avoid large power demands while this error is active to prevent deterio-
ration.
- Try not to use the system in extreme temperatures (less than 10°C or
more than 40°C).
- Allow to charge until the error disappears (around 3,5 hours).
- If the error persists, perform several discharge - full charge cycles (from
100% to 50% battery load).
- If after a maximum of 5 cycles, the error is still present at the battery,
contact your bicycle manufacturer.
19
Publicidad
