Printing Stored Results (Print/Mem); List Of Coded Errors - Chauvin Arnoux C.A 6250 Manual De Instrucciones

3.7.2 Printing stored results (PRINT MEM)
This function is used to print the content of the instrument's memory.
Press the PRINT MEM key (
The secondary display unit indicates the OBJ:TEST number 01 : 01 as start address for printing.
The main display unit indicates the last recording in memory, e.g. 12 : 06, as end address for printing.
To change the printing beginning/end addresses, use the normal modification procedure
(4and 56keys).
To exit without printing, change the setting of the rotary switch.
To start printing, press the PRINT key again.
To stop printing, change the setting of the rotary switch.
3.8

LIST OF CODED ERRORS

Err 1 Battery charge too low
Err 2 Internal problem
Err 3 Impossible to measure battery charge
Err 4 Impossible to measure temperature
Err 5 Internal temperature too high - Let the instrument cool down
Err 6 Measuring current not established
Err 7 Measurement out of range
Err 8 Internal problem
Err 9 Measurement cycle stopped
Err 10 Temperature sensor incorrectly connected or missing
Err 11 Current-circuit wires incorrectly connected
Err 12 Voltage-circuit wires incorrectly connected or measured resistance too high
Err 13 Residual voltage too high
Err 21 Adjustment out of bounds
Err 22 Measured value out of bounds
Err 23 Edition out of bounds
Err 24 Cannot write to back-up memory
Err 25 Cannot read in back-up memory
Err 26 Memory full
Err 27 Memory empty: no data available
Err 28 Memory check problem
Err 29 Object or test number incorrect
Warning:
If error message 2, 3, 4, or 8 appears, the instrument must be switched off and sent to a
qualified organization for repair.
+ PRINT).
39