BDS Maschinen MAB 1300 Instrucciones De Manejo página 52

Preparation
MK tool/industrial tool holder
52
NOTE
► When using tools with MK4 taper, the tool holder with retai-
ner must be dismantled.
For further information, see the section Dismantling/as-
sembling the tool holder.
Fitting the tool/industrial tool holder
Before fitting, clean the shank of the tool, adapter or industri-
‹
al tool holder and the morse taper (5) of the machine.
Insert the tool from below into the morse taper (5) of the
‹
machine.
NOTE
► When using tools/adapters with MK3 taper, use MK4:3
adapter sleeve.
Removing the tool
Turn the tool until the ejector pin (6) slips into the opening.
‹
Lever the tool out using the ejector pin or loosen the tool by
‹
tapping the ejector pin.
MAB 1300