Drilling With The Machine - BDS Maschinen MAB 1300 Instrucciones De Manejo

Operation

Drilling with the machine

Drilling with twist drills
58
When drilling with twist drills, proceed as follows:
Remove the tool holder with the retainer.
‹
Push twist drills with MK taper from below into the morse
‹
taper (5) of the machine.
Push twist drills with straight shank into the drill chuck after
‹
fitting the drill chuck.
Place the machine at the working location, align it and switch
‹
on the magnetic clamps.
Select a suitable speed and switch on the machine.
‹
NOTE
Observe the following instructions when drilling with twist drills:
► Under excessive pressure, the drill can wear out and the
machine can be overloaded.
► Pay attention to the production of shavings. In the case of
larger drilling depths, break shaving regularly.
MAB 1300