Publicidad
Idiomas disponibles
Idiomas disponibles
After cleaning, the robot leaves a
mark on the glass surface.
The robot has stopped operating
due to power cut and it is too high
to reach it.
The robot has stopped operating
and the red light indicator blinks.
When the robot is turned on, the fan
does not run and there is no alarm.
Wen using the robot for the first
time, it is slow or even fails.
When activated it emits a failure
signal.
Possible reasons for the robot to
slip and not climb.
The robot does not work properly.
Possible causes:
The cloth is too dirty or too wet. Clean it or replace
it.
Carefully pull from the safety rope and grab the
robot.
Turn off the power switch.
Carefully pull from the safety rope and grab the
robot.
Make sure there are no obstacles on the window or
glass. If there are any, remove them.
Check if there is air leakage caused by a gap or
uneven window frames.
Check the power cord.
Check the red light in the low sensor and/or the
surface of the device is on.
Orange light without beep:
Low battery, fully charge the robot.
Moisten the cleaning cloth with some water or
glass cleaner directly on the cloth or glass. After
the cleaning cloth is wet, place it in the machine's
cleaning ring.
The robot tests its operating when activated. If you
notice that the friction is too long or too short, it will
warn you of a fault. Possible reasons may be:
The cloth is too dirty.
The glass is too clean and the surface slips.
If the glass is wet, the surface slips.
There are stickers on the glass surface.
Check the mains connection.
Humidity, stickers...
The cloth is too wet.
The window is too clean.
When humidity is very low (rooms with air
conditioning).
Do not respect the safety distance with the frame.
The cloth is too dirty.
Different types of surfaces in the same cleaning
area (sand area, stickers...)
The screw does not make a good connection.
ENGLISH
53
Publicidad
