Panasonic ES-ALT4B Instrucciones De Funcionamiento página 14

• When the switch lock lamp ( ) blinks after the
power switch is pressed, the shaver will not
operate as it is locked. Hold the power switch for
more than 2 seconds to unlock. (See page 16.)
4
Press the blades gently in
the palm of your hand, mix
the facial cleanser etc.
around and move the blades
up and down to make foam.
• If there is insufficient foam, add
slightly more water, hot water or
facial cleanser etc. to make it
easier to create foam.
►Notes
• Do not use shaving agent (excluding foam), facial
cleansing foam (with scrubbing compounds) or soap
as these may cause the blades to clog, or be unable
to make foam.
14
Shaving beard
• Before shaving, check that the cleaning shutter is closed.
1
Press and shave.
• The "shaving sensor", which
automatically adjusts the power
depending on the beard
thickness, will operate.
It will shave with high power on
areas where the beard is heavy,
and reduce the power on areas
where the beard is thin, to reduce
burden on the skin.
Tips for better shaving
Apply the whole system outer foil
perpendicularly against the skin
and shave by slowly gliding the
shaver over the face against the
grain of the beard.
• The beard under the chin and
around the throat can be shaved
better by stretching the skin so
the beard will stand.
• To prevent damaging the system
outer foil, do not shave with only a
part of the system outer foil.