cecotec HIDROBOOST 1600 CAR&BIKE Manual De Instrucciones página 32

ENGLISH
1. PARTS AND COMPONENTS
Fig. 2
1. Main body
2. Hose
3. Water supply
4. Water inlet
5. High-pressure hose
6. Water outlet
7. Trigger gun
8. Power socket
9. On/Off switch
10. Wand
11. 3D TurboFlip nozzle
12. Spraying nozzle
13. Soap bottle
14. Anti-impurities filter
15. 360Brush (special for wheel rims)
16. EasyClean brush (special for gaskets)
*Parts 2, 3 and 8 not included.
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
This pressure washer has a packaging designed to protect it during transport. Unpack the
-
appliance and keep the original packaging box and other packaging materials in a safe
place. It will help you prevent any damage if the product needs to be transported in the
future. In case the original packaging is disposed of, make sure all packaging materials are
recycled accordingly.
- Ensure that all components are included and in good conditions. If any sign of visible
damage is observed or any of the product parts are missing, immediately contact the
official Technical Support Service of Cecotec.
H I D R O B O O S T 1600 CAR&BIKE
62
3. PRODUCT ASSEMBLY
- Fit the high-pressure hose (5) to the pressurised water outlet of the machine (6).
Attach the gun (7) to the high-pressure hose (5). Before putting the machine into operation,
-
make sure that the high-pressure hose (5) is completely unwound. The high-pressure
hose (5) should not tangle while in use.
- Install the spray nozzle (12) or the item to be used.
Connect the machine to the power supply (8) and to the water supply (3).
-
4. OPERATION
Setting the water pressure
Fig. 3
The angle of the water jet can be set with the spray nozzle by turning the tip. This will cause the
jet to vary from approximately 0° (narrow high impact jet) to 60° (wide spray jet).
This device has 3 modes:
Concentrated mode
Fig. 4
The angle of the water jet can be set with the spray nozzle. Rotate the nozzle to select the
direct jet, which has a high impact on the surface to be cleaned and provides thorough cleaning
of concentrated areas. This jet must be carefully used, as it can damage surfaces.
Warning
Pay special attention when cleaning surfaces susceptible to damage, such as vehicle bodywork
or rims, lacquered surfaces, wood, paintwork, etc.
Spray mode
Fig. 5
Turn the spray nozzle to select the fan spray pattern to cover large areas. This cleaning mode
offers excellent results without the risk of damaging surfaces. By using a wide spray pattern,
larger areas can be cleaned more quickly.
Turbo mode
Fig. 6
Use the 3D TurboFlip nozzle to clean with a turbo mode.
-
Water is distributed in a spiral-shaped jet. The 3D TurboFlip nozzle combines the power of
-
a direct jet of great impact with the efficiency of a 25º jet. This transforms the concentrated
jet into a conical jet that deep cleans larger areas.
ENGLISH
H I D R O B O O S T 1600 CAR&BIKE
63