Publicidad
Idiomas disponibles
Idiomas disponibles
vapours may be present. Do not use the machine in enclosed
buildings or near explosive atmospheres.
- Do not spray electrical and electronic appliances or cables.
- Do not remove the high-pressure hose from the machine
while the system is being pressurised. To depressurise the
device, turn it off, stop the water supply, and then press the
trigger 2 or 3 times.
- Do not activate the trigger lock system when the appliance
is in operation.
- Do not operate the appliance unless all parts are properly
connected to the main body (handle, trigger gun, nozzle,
etc.).
- Make sure to turn on the water supply before turning on
the pressure washer. Running the pump without water can
cause serious damage to the pump.
- Do not use the pressure washer if any parts are missing or
damaged. Check the condition of the product regularly and
repair or replace damaged or worn parts immediately.
- Use only the nozzle included with the product.
- Do not leave the high-pressure hose unattended while the
device is in operation.
- Hold the high-pressure hose and trigger gun firmly when
switching on and while using the machine.
- Do not leave the appliance running with the trigger released
for more than one minute, as this could damage the pump.
- This device is not designed to pump hot water. Do not connect
the appliance to a hot-water supply, as this will significantly
reduce the shelf life of the pump.
- Make sure the water inlet pressure is between 0.01 MPa and
0.4 MPa and that the inlet hose is at least 5 metres long.
- If the device is to be connected to a drinking-water supply,
install a disconnector on the water pipe to prevent dirty
HYDROB OO S T 1 60 0 C A R &G A R D EN
13
Publicidad
