Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Concentrated mode
The angle of the water jet can be set with the spray nozzle. Rotate the nozzle to select the
direct jet, which has a high impact on the surface to be cleaned and provides thorough cleaning
of concentrated areas. This jet must be used carefully, as it can damage surfaces. Fig. 3
Note
Beware of the recoil caused by the force of the water when activating the pressure washer.
Pay special attention when cleaning surfaces susceptible to damage, such as vehicle bodywork
or rims, lacquered surfaces, wood, paintwork, etc.
Spray mode
Turn the spray nozzle to select the fan spray pattern to cover large areas. This cleaning mode
offers excellent results without the risk of damaging surfaces. By using a wide spray pattern,
larger areas can be cleaned more quickly. Fig. 4
Turbo mode
Use the 3D TurboFlip nozzle to clean with a turbo mode. Water is distributed in a spiral-
shaped jet. The 3D TurboFlip nozzle combines the power of a direct jet of great impact with the
efficiency of a 25º jet. This transforms the concentrated jet into a conical jet that deep cleans
larger areas. Fig. 5
Product performance
Note
The motor of this pressure washer does not run continuously. It only runs when pressing the
trigger. Once the initial procedures in this manual have been carried out, turn the pressure
washer on and press the trigger to activate the pressure washer.
High-pressure hose angle based on surface
When spraying water against a surface, the jet achieves maximum impact when sprayed
head-on. However, this type of impact tends to embed dirt particles into the surface, creating
the opposite cleaning effect to the one desired. Therefore, the optimum angle for spraying
water against a surface is 45°. Spraying water at this angle improves the impact and allows for
a more efficient removal of dirt. Fig. 6
Distance from the surface to be cleaned
Another factor that determines the impact force of the water is the distance from the surface
to be cleaned. The impact and force of the water increases as the spray nozzle approaches the
surface.
HY D RO BOOST 16 0 0 C AR&G AR DE N
68
ORIGINAL MANUAL TRANSLATION
Publicidad
