Etac molift MRS Duo 2000 Manual De Usuario página 7

Supplied parts
2x
4x
4x
4x
4x
1x
Make sure the following parts are included in the
package�
Beware of sharp edges at the ends
of the boom.
Mounting Foot
1� Lay post on the floor�
2� Use the longest M10x50 bolts�
3� Use allen key, located in top of post) to screw
in bolts�
4� Align the foot, and screw in both bolts�
5� Make sure both bolts are properly fastened�
Important! Use the longest bolts
(M10x50)when installing foot,
shorter bolts may cause collapse.
Assembly
2x
2x
2x
2x
2x
Mounting boom to post
1� Slide washer and post in to boom�
2� Insert bolts M10x40 trough holes and washer
in boom�
3� Use allen key (located in top of post) to screw
in bolts�
4� Make sure both bolts are properly fastened
Do not stand under the boom
when mounting, use a stand or
similar to support the boom.
Mounting second post, trolley and end stop
1� Slide end stop, trolley and end stop into boom
in described order�
2� Slide washer and post in to boom�
3� Insert bolts trough holes and washer in boom�
4� Use allen key (located in top of post) to screw
in bolts �
5� Make sure both bolts are properly fastened�
Fasten end stops temporary during assembly� Must
be fastened properly with tools after adjustment
of height�
Important! Fasten end stops to
prevent trolley from moving when
adjusting post heigts. Moving
trolley can unintendedly hit the
operator.
7
Molift MRS Duo / www.etac.com
EN