Norwood LumberMax HD38 Instrucciones Originales página 9

Hydraulic Pump Installation
Install the pump assembly on the tongue
cross member (part #LM34-T0172): the
engine has to be located to the front of
the sawmill.
Using the pump mount brackets (item
#14), the 1/4" x 3" bolts (item #2) and the
nuts (item #1) secure the pump
Note: Position the pump so the carriage
or any other moving part doesn't touch
the pump.
Install the #6 SAE hydraulic 90 degrees
fitting (item #8) to the pressure port (P)
and the #6 SAE plug (item #18) to the
tank port (T) of the pump as shown on
the picture.
P
T
Install hydraulic hose clamps (item #11,
12 and 13) as per illustration on next
page. See illustration on next page.
EN–5