cecotec CONGA WINDROID 880 SPRAYWATER SMART CONNECTED T Manual De Instrucciones página 56

ENGLISH
When using the robot for the first time, it
is slow or even fails.
When activating, it emits a failure signal
(red sensor and sound signal).
Possible reasons for the robot to slip and
not climb.
The robot does not work properly.
Possible causes:
The robot does not spray water or glass
cleaner.
6. TECHNICAL SPECIFICATIONS
Product: Conga WinDroid 880 SprayWater Smart Connected T
Product reference: 05872
90 W, 100-240 V~, 50/60 HZ
Li-ion rechargeable battery:
14.8 V DC
600 mAh
Charger:
Input: 100-240 V~, 50/ 60 Hz 2.0 A
Output: 24 V DC 3, 75 A.
56
Moisten the cleaning cloth with some water
or glass cleaner directly on the cloth or glass.
After the cleaning cloth is wet, we place it in
the machine's cleaning ring.
The robot tests its operating when activated.
If you notice that the friction is too long or
too short, it will warn you of a fault. Possible
reasons may be:
The cloth is too dirty.
The glass is too clean and the surface slips.
If the glass is wet, the surface slips.
There are stickers on the glass surface.
Check the mains connection.
Humidity, stickers...
The cloth is too wet.
The window is too clean.
When humidity is very low (rooms with air
conditioning).
Does not respect the safety from the frame.
The cloth is too dirty.
Different types of surfaces in the same
cleaning area (sand area, stickers...)
The screw does not make a good connection.
Check the spray mode is activated.
Clean the nozzle with a soft, clean cloth.
Check the water tank is full.