PNI WK400 Manual De Usuario página 12

Cordless driver drill
Warnings
• Remove the drilling tool from the battery before charging the battery.
• Mount the accessories on the drilling tool before mounting the battery.
• To reduce the risk of injury, wear personal protective equipment when
using the drilling tool.
Introduction
1. Chuck
2. LED light
3. On/off button
4. Battery installed
5. Direction control button
and on/off button lock
6. Speed control lever
7. Operating mode
adjustment ring
8. Torque adjustment ring
Turn on and Turn off
1. Press the control button to start the drilling tool. The LED will be lit as long
as the button is pressed.
2. To stop the drilling tool, release the button.
Speed control
Always move the speed control button fully into the correct position.
If you use the drilling tool with the speed control button positioned intermediate
between position "1" and position "2", the power tool may be damaged.
Do not use the speed control button while the drilling tool is running. The
User manual 12