Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Disconnect the negative (–) battery terminal of
the accessory battery before beginning the installation.
• Always wear protective eyewear when using tools.
• Choose a safe mounting location. Check clearances on both
sides of a planned mounting surface. Be sure that screws
or wires will not puncture the vessel hull, fuel lines, or wiring
harnesses, and that wire routing will not interfere with the safe
boat operation. Use caution when drilling or cutting in the
mounting area.
• Choose a location that provides enough air circulation.
• Do not mount the amplifier with the heat sink facing downward,
as this interferes with cooling.
• Mount the amplifier so that it will not be damaged by the feet of
passengers or shifting cargo.
WIRING FOR POWER AND GROUND
At amplifier:
+12V
Fuse holder, fuse
18" (46cm)
Battery
aftermarket stereo REM out
(used only with low-level signal inputs)
At ground location:
Factory Bolt
Ring Connector
Note: Remove any paint
below ring connector
WIRING FOR INPUT SIGNAL
Low-level signals
From stereo subwoofer
Note: when using low-level signals and remote turn-on lead, set
the "
" switch to "
switch to "
".
REM
GND
Chassis ground (–)
Remote turn-on to
Ground Wire
Star Washer
low-level outputs
" and the "
High-level signals
Loosen
Screws
Stereo front or
rear speaker wires
Note: when using high-level signals, set the "
switch to "
" and the "
sound plays, change the "
CONNECTING TWO MARINE A1000
AMPLIFIERS FOR EXTRA POWER
To connect two Marine A1000 amplifiers, use an RCA patch cable
to connect the "PRIMARY OUT" of the primary amplifier to the
"SECONDARY IN" of the secondary amplifier. Set the Primary/
Secondary switch to "PRIMARY" on the primary amplifier, and to
"SECONDARY" on the secondary amplifier.
"
Insert
Tignten
Wires
Screws
" switch to "
". If no
" switch to "
".
EN
"
Publicidad
