Baxtran SAN Manual De Usuario página 11

03. OPERATION
3.1. ZERO THE DISPLAY
You can press the
within 2% of power up zero. This will usually only be necessary when the pan is empty. When the zero point is
obtained the display will show indicator for zero.
The scale has an automatic rezeroing function to account for minor drifting or accumulation of material on the
platform. However you may need to press the
the platform is empty.
3.2. TARING
Zero the scale by pressing the
Place a container on the pan a value for its weight will be displayed.
Press the key to tare the scale. The weight that was displayed is stored as the tare value and that value is
subtracted from the display, leaving zero on the display.
The "NET" indicator will be on. As product is added only the weight of the product will be shown.
When the container is removed a negative value will be shown. If the scale was tared just before removing the
container this value is the gross weight of the container plus all products that was removed.
The zero indicators will also be on because the platform is back to the same condition it was when the
last pressed.
3.3. WEIGHING UNIT SHIFT
Press key and
turn on (kg or lb).
04. PARAMETERS AND CALIBRATION
4.1. ENTER SETTING MODE
To set parameters, first turn on the weighing scales, hold the
CAL".
4.2. CALIBRATE
After enter setting mode, the display will show "F1 CAL". press
after STABLE indicator on, press
calibrate weight, after you select, put the calibrate weight on, after STABLE indicator on, press
will auto restart. calibration finished.
4.3. CHANGE CAPACITY
After enter setting mode, the display shows "F1 CAL", press
para introducir, presione a tecla
4.4. SET RESOLUTION
After enter setting mode, the display shows "F1 CAL", press the
enter, press the key select current resolution. Press the
4.5. CHECK INTERNAL COUNTS
After enter setting mode, display shows "F1 CAL", press
enter, display shows internal counts, press
4.6. SET AUTO POWER OFF TIME
After enter setting mode, display shows "F1 CAL", press
to enter, display shows current turn off time, this function have four model, include(3/5/15MIN/OFF), press the
key to return setting mode.
key at any time to set the zero point from which all other weighing and counting is measured,
key if necessary. The zero indicator will be on.
key to together will change weighing unit in the weight mode, relevant weighing unit mark
key again, display shows the calibrate weight, you can press
key to enter, press
key to rezero the scale if small amounts of weight are shown when
key during self-checking, until display show "F1
key, display shows "UNLD", empty the platter,
key select , until display shows "F3 CAP ", press
key to select capacity , press zero key to sure.
key display shows "F2 RES " press the
key confirms.
key select , display shows "F4 INP", press
key to return setting mode.
key select , until display shows "F5 oFF", press
USER'S MANUAL SAN
key was
key to select
key to sure, scale
key to
key to
key
EN EN
11