Publicidad
Idiomas disponibles
Idiomas disponibles
DW788/383329
8/6/02
10:35 AM
Page 7
FIG. 11
FIG. 9
BRUSH
INSPECTION
CAPS
FUSE CAP
(PRESS TO RELEASE)
BEVEL LOCK KNOB
BEVEL POINTER
BEVEL SCALE
NOTE: Do not lift saw by upper arm. Damage will occur.
FIG. 10
Overload Protector
Your scroll saw is equipped with a 3 amp overload protection fuse. If
your scroll saw becomes overloaded and stops operating, turn off the
scroll saw, check for a blown fuse by removing the fuse cap
(Figure 11). Your scroll saw uses fuse #3AG Fast Acting,
1 1/4" long x 1/4" diameter.
Maintenance
BRUSHES
Inspect carbon brushes regularly by unplugging tool, removing the
brush inspection cap (Figure 11) and withdrawing the brush assembly.
Keep brushes clean and sliding freely in their guides. Always replace
a used brush in the same orientation in the holder as it was prior to its
removal. If the brush is worn down to 3/8", it must be replaced. Use
only identical D
WALT brushes. New brush assemblies are available
E
7
Publicidad
