Descargar Imprimir esta página

Ego Power+ CS1804 Manual De Instrucciones página 34

Publicidad

Idiomas disponibles

Idiomas disponibles

Underbucking
Begin on the underside of the log with the
top of the saw against the log; exert light
pressure upward. During underbucking,
the saw will tend to push back at you. Be
prepared for this reaction and hold the
saw firmly to maintain control.
When the log is supported along its
entire length, it should be cut from
the top (overbucking) (Fig. 21).
When the log is supported on only
one end, cut 1/3 the diameter from
the underside (underbucking).
Then make the finishing cut by
overbucking to meet the first cut
(Fig. 22).
When the log is supported on both
ends, cut 1/3 of that diameter from
the top overbuck. Then make the
finished cut by underbucking the
lower 2/3 to meet the first cut
(Fig. 23).
34
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1800/CS1800-FC
21
Log Supported Along the Entire Length
22
Log Supported One End
2nd Cut Overbuck (2/3 Diameter) to Meet 1st Cut
(To Avoid Pinching)
1st Cut Underbuck (1/3 Diameter) to Avoid Splintering
23
Log Supported Both Ends
1st Cut Overbuck (1/3 Diameter) to Avoid
Splintering
2nd Cut Underbuck (2/3 Diameter) to Meet 1st Cut
(To Avoid Pinching)
Cut From Top (Overbuck)
Avoid Cutting Earth

Publicidad

loading

Este manual también es adecuado para:

Cs1804-2Cs1800Cs1800-fc