Goodyear GY 2802PS Manual De Instrucciones página 34

English • Owner´s manual
ATTENTION!
Turn the battery off and disconnect the tool before checking, repairing or cleaning it to prevent it
from starting accidentally and causing injury or cuts.
WARNING
Wear protective gloves before handling the blade.
When cleaning your scissors, keep the following considerations in mind. Frequent
checking of the tool will make it safe and reliable.
- Do not wet or spray the tool with water or any other liquid and do not immerse it, it may cause a
short circuit inside the tool.
- Keep the handle clean, do not add supplements or elements that may hinder the ventilation of
the motor. Use a cloth to clean the tool. Do not use detergents to clean it as this may damage the
surfaces.
- Clean the blade after each use, protect it with protective oil.
Cleaning and greasing. Replacement of blade or counter blade. Disassembly and
assembly.
This process is very important because it determines the quality of the cut, the life of the blade and the
life of the battery. The more difficult it is to cut, the more your appliance consumes.
The wear of the blade should be controlled and checked daily and on a regular basis, you should shar-
pen and lubricate the blade daily. Blades in poor condition or poorly sharpened blades overload the tool.
Damage resulting from use with poorly sharpened blades is not covered by warranty.
- After opening the blade, please turn off the battery.
- Both sides of the movable blade are polished using sharpening stone forming the angle of the
section with the blade.
- After polishing the blade, wash it, connect to the power line, test, close the blade and finish.
If additional spare parts are required, always use high quality, original Goodyear replacement parts.
1. For safety, remove the battery.
2. Follow the step-by-step instructions shown in the pictures to remove the blade.
3. After replacement, wash it, turn on the blade, test it and close it.
34