YATO YT-82604 Manual Original página 14

EN
to freeze on these elements. Do not use high pressure washers to clean the fl exible shaft and vibrating poker.
Wipe dry after cleaning.
Do not immerse the drive unit in water or any other liquid. Do not direct water or other liquid to the drive unit. Clean the housing of
the drive unit with a slightly wet soft cloth or sponge and then wipe thoroughly. Clean the ventilation holes with a soft brush, a soft
brush or a stream of compressed air with a pressure of not more than 0,3 MPa.
After every 100 hours of operation, the fl exible shaft and vibrating poker should be inspected and lubricated by the manufacturer's
authorised service.
Spare parts
Detailed list of spare parts of the product can be found in the "Downloads" section, in the product data sheet, on the TOYA SA
website: toya24.pl
Product storage
The product should be stored disconnected from the power supply, thoroughly cleaned and dried. The fl exible shaft shall be
detached to the drive unit. Store the product indoors. Secure against unauthorized access. Ensure adequate ventilation to prevent
water vapour condensation at the place of storage. The place of storage should protect the product from weather conditions.
Transportation of the product
During operation, transport the product over short distances while maintaining the drive unit and the fl exible shaft. If transported
over longer distances, remove the fl exible shaft from the drive unit. Transport both components separately. The product should
be transported in unit packaging or other hard packaging, providing protection against shocks. Protect the product from moisture
during transport.
O R I G I N A L I N S T R U C T I O N S
14