Stalgast 801556V06 Instrucciones De Uso página 36

arrows to change the data on display 2 into:
a. programming of temperatures and times
CUSTOMER SETTINGS
Press again. The displays will show the following data:
-rinsing temperature (70-95
The arrows can be used to adjust the temperature on display 2.
Press again. The displays will show the following data:
o
temperature (40-70 C).
The arrows can be used to adjust the temperature on display 2.
SERVICE SETTINGS (it is recommended that they are not changed)
Press again. The displays will show the following data:
tization temperature (50-90
The arrows can be used to adjust the temperature on display 2.
Press again. The displays will show the following data:
release after the activation of the pressure switch (0-40 sec.) determining the water level.
The arrows can be used to adjust the time of water release on display 2.
Press again. The displays will show the following data :
time (8-15 sec.).
The arrows can be used to adjust the sanitization time on display 2.
During the setting of the above parameters the display screen is blinking, and the values of the para-
meters can be changed using the arrows.
Function Name
P1
P2
P3
P4 time for water release after the activation of the pressure switch
P5
b. programming of cycle duration
Press Display 1 will indicate:
o
C)
o
C).
RECOMMENDED SETTINGS
Function description
sanitization (rinsing) temperature
washing temperature
minimal sanitization temperature
sanitization (rinsing) time
- 36 -
. This is the factory-set password.
- sanitization-
- washing water
- minimal sani-
time for water
Recommended value
90ºC
60ºC
82ºC
0 seconds
15 seconds
- sanitization