Stalgast 801556V06 Instrucciones De Uso página 38

overflow plug and wait until the water is drained off completely from the tank. Put the overflow plug
back in its place, close the door of the device.
Do not turn the device off when the water is still in the tank. Before turning the device off, al-
ways empty the tank of water. In the event the device will no longer be used, after the completion of
the above and the possible initiation of a regeneration cycle, it is necessary to turn the device off by
pressing the switch. The main switch should then be turned off and the water valve should be closed.
7. PROBLEMS, CAUSES, SOLUTIONS
Note: If the activities for the removal of the faults described in the table below did not provide the
desired result, please contact the repair service (qualified technical personnel).
PROBLEM
The device does not turn on
Washing process lasts too
long
The device does not wash
dishes
Spots on forks, glasses and
vessels
Dishwasher does not rinse
Leaking solenoid valve
The water pressure in the
device is too low
The pump is not pumping
out water
CAUSE
The doors of the device are not closed
properly
Blown fuse
Improper connection to the electrical
network
Wash water temperature is not correct
Incorrect water level in the chamber of the
device
Broken washing pump
Low pump pressure
Water temperature too low
Incorrect washing agent
Arms covered with lime scale or the presen-
ce of foreign bodies
Empty detergent container
Faults in the water treatment device
Incorrect arrangement of the dishes
Rinse water temperature is too high
Incorrect water pressure
Water hardness level is too high
The detergent did not work, because of
dirty water in the device
Incorrect drying of the dishes
Incorrect rinse agent
Contaminated water inlet filter
Low water pressure
Broken rinse pump
Contamination of the solenoid valve
Contaminated water inlet or solenoid valve
filter
Low hardness of water in the water network
Clogged pump
Faulty pump
- 38 -
SOLUTION
Open and then close the door again
Replace the fuse (call the service)
Check the connection to the electri-
cal network
Set the correct temperature
Clean the water inlet filter
Call the service
Clean the pump filter
Adjust the water heating time
Contact the manufacturer
Clean the arms and remove the
foreign bodies
Fill the container
Kontakt mit Service
Arrange the dishes in accordance
with the instructions
Set the correct temperature
Clean the filters
Check the water hardness
Change the water in the device
Change the water in the device
Contact the manufacturer
Clean the filter
Clean the pump filter and the sole-
noid valve
Call the service
Call the service
Note: during the installation of the
device foreign bodies or unwanted
chemical compounds from the water
supply could have contaminated the
solenoid valve.
Clean the water inlet or solenoid
valve filter
Contact a plumber
Contact the service