Descargar Imprimir esta página

Troy-Bilt 01925 Manual Del Propietário página 15

Ocultar thumbs Ver también para 01925:

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 5: Maintenance
Generator
Maintenance
Generator
maintenance
consists
of keeping
the unit dean
and dry. Operate and store the unit in a dean dry
environment where it wi[[ not be exposed to excessive
dust, dirt,
moisture or
any corrosive
vapors.
Cooling
air
slots
in the generator
must not
become
dogged
with
snow,
[eaves or any other
foreign
material
NOTE: DO NOT use a garden hose to clean
generator.
'Water
can enter
engine
fuel system
and cause problems.
In
addition_
if water
enters
generator
through
cooling
air
s[ots_
some of the water wi[[ be retained in voids and cracks of
the rotor and stator winding insulation.Water
and dirt
buildup on the generator internal windings will eventually
decrease the insulation resistance of these windings.
WARNING
WHEN
ADJUSTING
OR
MAKING
REPAiRSTOYOUR
GENERATOR
, Disconnect
the spark plug wire from the spar[< plug and place
the wire where it cannot contact
spark plug.
WHENTEST[NG
FOR ENGINE
SPARK
Use approved
spark
plug testen
, DO NC)T check for spark with spark
plug removed.
Battery
Maintenance
Other than float charging, as described in "How to Use the
Battery Charger", no maintenance is required for the
battery. Keep the battery and terminals clean and dry.
IMPORTANT:
Battery charging should be performed
in a
dry location, such as inside a garage.
° Use a damp cloth to wipe exterior surfaces dean.
DO NOT expose generator to excessive moisture, dust, dirt,
or corrosive vapors,
DO NOT insert any objects through cooling slots,
° Use a soft brisde brush to loosen caked on dirt or oil
° Use a vacuum cleaner to pick up loose dirt and debris.
° Use low pressure air (not to exceed 25 psi) to blow away
dirt. Inspect cooling air slots and opening on generator.
These openings must be kept clean and unobstructed.
D ata Tag
Data tag information is very important if you need help
from our Customer Service Department
or an authorized
service dealer.
, The data tag (Figure 18) is located either on the base
plate of the generator. For future reference, please copy
the model, revision, and serial number of the generator in
the space below.
[
MODEL
[
REV NO
[
SERIAL
[
AC VOLTS
[
AC AMPS
[
AC WATTS
[
DC VOLTS
[.................................................................................................
DC AMPS
[
Single Phase / 60 Hz / 3606RPM
Rated at 40° C / Class F hsulation
O TROY BILT
._
Here
Copy Serial
Number
Here

Publicidad

loading