Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
BEFORE
STARTmNG THE
ENGmNE
[ne
Oil
° Race genera[or
on a level surface.
1
• Refer to engine manuaIfor oil fill information.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
° Refer to engine owner's manuaHand follow oiH
recommendations
and instructions.
NOTE:
Check oiH often during engine break-in. Refer to
engine owner's manual for recommendations.
NOTE:
The generator
assembly rotates on a prehbricated
and sealed ball bearing that requires no additional
lubrication
for the life of the bearing.
Add
Fuel
NOTE:This
gasoline
engine
is certified
to operate
on
gasoline. Exhaust Emission Control System: EP1(Engine
Hodifications).
WHEN
ADDING
FUEL
Turn generator
OFF and let is cool at [east 2 minutes before
removing fueJ cap, Loosen cap slowly to relieve pressure in
_:anI<,
Fill f ueltank outdoors,
DO NOT overfill tank.AHow
space for" fuel expansion.
Keep fueI away from sparks, open flames, pilot lights, heat, and
other ignition sources
DO NOT light a cigarette
or smoke.
1
[.
Use c[eam fresh,
regular
UNLEADED
fuel with
a
minimum
of 85 octane.
DO
NOT
use fuel which
contains
HethanoL
DO
NOT
mix oil with
fuel
2.
Clean
area around
fuel fill cap_ remove
cap.
3.
Slowly
add regular
unleaded
fuel to fuel tank. Be careful
not to overfill.Allow
about
2.25" of tank
space for fuel
expansion (Figure2).
Fuel
4.
Replace "1.5" with "2.25" fuel fill level given in engine manual
FaiIure I:o follow this instruction
may cause fueI _:o overexpand
and spill f rom _:anl<,
Instal[ rue[ cap and wipe
up any spiHed fuel
Remove
Cover
on Stare Switch
A protective plastic cover is placed over the start switch to
prevent
the generator
from
being started.
° Open
cap on battery
float
charger.
° Remove
and discard
plastic
cover
over
the start
switch
(Figure
3).
o Replace cap on battery float charger.
O
Publicidad
