ABB 6AGC082155 Guía De Instalación Rápida página 2

—
QUICK INSTALLATION GUIDE
Load management
This Quick Installation Guide (QIG) briefly describes the most important installation and configuration steps for the load
management functionality of the EV Charger. This QIG is not a replacement to the manufacturer installation manual of the
EV Charger and the Energy meter, it is complimentary to these documents. More detailed information is available in the EV
Charger installation manual and the Energy meter installation manual. This QIG is intended to be used by qualified electrical
personnel (installer) who are responsible for the installation of the EV Charger and Energy meter for the purpose of the
load management functionality.
Before installing the load management functionality, read this QIG carefully and attentively. Follow the instructions in this
QIG. ABB is not responsible for any damage that has been caused by not or incorrectly following and executing the
instruction described in this QIG.
General:
•
Warning – Electrical equipment should only be installed, accessed, serviced and maintained by qualified
electrical personnel.
•
The electrical installation should be designed and constructed according to local laws, safety and electrical
regulations.
•
Make sure that the main switch of the distribution cabinet (Consumer Unit) is set to the OFF position,
before starting the installation work. Do a voltage check to make sure that the electrical power is turned
OFF.
Disclaimer
The information in this document is subject to change without notice and should not be construed as a commitment by
ABB E-mobility B.V.. ABB E-mobility B.V. assumes no responsibility for any errors that may appear in this document.
In no event shall ABB E-mobility B.V. be liable for direct, indirect, special, incidental, or consequential damages of any nature
or kind arising from the use of this document, nor shall ABB E-mobility B.V. be liable for incidental or consequential damages
arising from use of any software or hardware described in this document.
Warning – Working with high voltage is potentially lethal. Persons subjected to high voltage may suffer cardiac arrest,
burn injuries, or other severe injuries. To avoid such injuries, make sure to disconnect the power supply before you start
the installation.
Warning – For safety reasons it is recommended that the equipment is installed in a way that makes it impossible to
reach or touch the terminal blocks by accident.
The best way to make a safe installation is to install the unit in an enclosure. Further, access to the equipment should be
limited through use of lock and key, controlled by qualified electrical personnel.
Warning – Do not operate the equipment outside the specified technical data.
Installation Requirements – To comply with the protection requirements the energy meter must be mounted in protection
class IP 51 enclosures, or better, according to IEC 60259.
Caution – Be careful that no liquid gets into the meter and EV Charger since it may damage the equipment.
Warranty and accuracy are void if sealing labels are removed.
English
2