Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the
clipper (Figure D), and with the clipper turned "ON", push the blade towards the
clipper to lock into position.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil. If
you have a detachable blade unit, you can change your blade in order to maintain a
comfortable temperature; using multiple blades of the same size is popular among
professionals.
CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES
Blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it's a sure sign blades need oil. The clipper should be
held in the position shown in Figure F to prevent oil from getting into the motor.
Place a few drops of Andis Clipper Oil on the front and side of the cutter blades
(Figure G). Wipe excess oil off blades with a soft dry cloth. Spray lubricants contain
insufficient oil for good lubrication, but are an excellent clipper blade coolant.
Discontinue use of broken or nicked blades to prevent injury. You can clean the
excess hair from your blades by using a small brush or old toothbrush. To clean the
blades we suggest to immersing the blades only into a shallow pan of Andis Blade
Care Plus, while the clipper is running. Any excess hair and dirt that has accumulated
between the blades should come out. After cleaning, turn your clipper off and dry
blades with a soft, dry cloth and start clipping again.
For more information on how to care for your clipper and view how-to tutorials, visit
andis.com. WARNING: Cutting blades may become hot after prolonged use.
CHANGING THE BLADE DRIVE ASSEMBLY
If your clipper blades no longer cut properly (be sure to try more than one blade,
since the blade currently being used may be dull), it could be that your blade drive
assembly needs replacement.
To change the blade drive assembly:
1. Remove blade set (Figure D).
2. Remove drive cap by grabbing both sides at top and sliding off (Figure H).
3. Remove blade drive mounting screws (Figure I).
8
Publicidad
