EQUATION COOL 9K 2 Manual De Instrucciones página 47

Emptying the water tank
In cooling mode, the internal water tank must be emptied regularly. If the display shows
emptied.
Switch off the device, bring it above a
container and remove the rubber cap
TROUBLESHOOTING
Malfunctions are often due to minor causes; consult the table below before contacting the after-sales service.
This can save you time and avoid unnecessary expenses.
Problem
The device does not work
The remote control does not work
The room is not cooled
The device vibrates abnormally
The display shows
The display shows
In the event of a persistent problem, contact the after-sales service of your store.
Let the water drain into the tank.
Causes, solutions
Check the power supply.
Check the fuse.
Check the battery
Check that the "Cooling" mode is active
Check for good air circulation at the inlet and outlet
Check that the filter is clean and not clogged
Check that the setpoint temperature is lower than the ambient temperature
Check that the doors and windows are properly closed
Check that it is installed on level and stable ground.
Empty water tank
Please contact After Sales Service
, ,
Put back the rubber cap and restart
the appliance.
47
EN
, the tank must be