cecotec IRON PROFESSIONAL Manual De Instrucciones página 21

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
Filling opening
1.
2. Tank handle
3. Water tank
4. Base
Cable storage slot
5.
6. Temperature knob
7. Soleplate
8. Handle
Steam trigger
9.
10. Lock lever
11. Iron
12. Heat-insulated bracket
13. Control panel
Fig. 2.
- 70 ºC-120 ºC (Minimum)
- 100 ºC-160 ºC
- 140 ºC-210 ºC
- 170 ºC-225 ºC (Maximum)
Buttons and indicator lightsFig. 3
- Power button
- Steam level selection button
- Power indicator light
- Descaling indicator
- Filling indicator
- Low-steam indicator
- Medium-steam indicator
- High-steam indicator
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
40 IRON PROFESSIONAL
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Steam station
- Instruction manual
3. OPERATION
First use
- Before switching on the iron, remove all protective stickers and adhesives from the
appliance.
- Fill the water tank with water and heat up the iron. Then, iron over a piece of damp cloth for
several minutes for the purpose of removing any residue on the soleplate.
- Note: some parts of the iron have been lightly oiled, which may cause the iron to emit a
slight smoke when it is first switched on. Smoke will disappear after a short time.
- It is normal for the appliance to give off a strange odour on first use. The smell will
disappear after a short time.
- When you switch on the appliance, the steam generator may make a pumping sound. This
is normal. This sound indicates that water is being pumped into the steam generator.
- The soleplate may automatically emit steam for approximately three seconds while
heating up.
Filling the water tank
- Remove the water tank by pulling the handle when the iron is switched off. Fill the tank
through the filling opening.
- Make sure the water does not exceed the MAX. mark on water tank.
On/off
- The appliance must be plugged in for switch-on. Press the power button: the power
indicator light will switch on. Low Steam is the default steam setting upon switch-on, so
the corresponding indicator light will come on.
- Press the power button for two seconds to switch off the appliance.
Steam level selection
- The steam level can be changed by pressing the steam level selection button.
- Depending on which one is chosen, the corresponding indicator light will flash and remain
steady once the iron is finished preheating.
ENGLISH
IRON PROFESSIONAL 41