cecotec IRON PROFESSIONAL Manual De Instrucciones página 23

ENGLISH
Ironing tips
- Always check for ironing instructions on the garment label. If present, follow these
instructions.
- The appliance heats up faster than it cools down. Therefore, start by ironing garments that
require lower temperatures, such as synthetic-fibre garments.
- If the garment is composed of different types of fibres, you should always select the
lowest ironing temperature.
- Silk and other fabrics that tend to be shiny should be ironed on the inside.
- Velvet and other textures that become shiny quickly should be ironed in the same direction
with light pressure. Always keep the iron moving.
- Pure-wool fabrics (100% wool) can be ironed with the steam iron. Set the temperature
knob preferably to the third position and use a dry cloth between the iron and the garment.
- Never iron over zips or rivets. This may damage the iron.
Warning
When woollen fabrics are ironed, they may become shiny. In this case, it is advisable to turn the
garment inside out and iron on the inside.
Adjustment Temperature
1 70 ºC-120 ºC
2 100 ºC-160 ºC
3 140 ºC-210 ºC
Maximum 170 ºC-225 ºC
4. CLEANING AND MAINTENANCE
- Turn off, unplug the appliance from the power supply, empty the water tank (do it after
each use) and allow it to cool down completely.
- Wipe off any residue left on the soleplate with a damp cloth or a non-abrasive (liquid)
cleaner.
-
Warning
Do not use abrasive cleaners or scouring pads to clean the device.
- Use a soft, damp cloth to clean the surface of the device. Wipe off any water droplets on
the base and the heat-insulated bracket with a dry cloth.
- If any fabric has stuck to the soleplate, use a cloth dampened with vinegar to clean the
sole.
44 IRON PROFESSIONAL
Fabric
Acetate, elastane, polyamide,
polypropylene.
Cupro, polyester, silk.
Triacetate, viscose, wool.
Cotton, linen.
Cleaning/descaling
- To remove the mineral residue accumulated inside the steam generator, follow the steps
below.
- Turn the base upside down and place it horizontally on a flat surface. Make sure that the
base is stable.
- Gently pry the cover with a screwdriver and remove it (fig. 7).
- Refill the steam generator tank.
- Put the cover back in position by pressing on the hole and shake the base of the iron to
remove any mineral residue that may be stuck to it.
- Open the cover again and empty the steam generator tank.
- Close the cover again.
Warning
- To avoid burns, make sure the steam generator has cooled down completely.
- If the appliance is not going to be used for a long time, empty the water tank. Place the iron
on the support and move the lock lever to the locked position.
5. TECHNICAL SPECIFICATIONS
05199_Iron Professional
2520-3000 W, 220-240 V~, 50-60 Hz
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
6. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the cells/batteries/accumulators and take them to a collection point
designated by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
ENGLISH
IRON PROFESSIONAL 45