cecotec IRONHERO 3200 SMART ABSOLUTE Manual De Instrucciones página 19

ENGLISH
Fig. 2
- Connect the plug of the product to a grounded circuit.
- Turn the mode knob to set the mode and select the appropriate temperature for ironing.
- The flashing orange light indicates that the soleplate is heating up and the red light
indicates that the selected temperature has been reached.
Dry ironing
1. Place the iron upright.
2. Plug the iron into the power supply.
3. Set the steam knob to the position.
4. Turn the mode knob to set the mode according to the type of fabric. The orange indicator
light will light up.
5. Preheat the iron until the indicator lights up red.
6. The iron is ready for use.
Steam ironing
1. Place the iron upright and make sure there is enough water in the tank.
2. Plug the iron into the power supply.
3. Set the steam knob to the or
4. Turn the mode knob to set the mode to WOOL or higher depending on the type of fabric.
The orange indicator light will light up.
5. Preheat the iron until the indicator lights up red.
6. The iron is ready for use.
Note
To prevent the soleplate from leaking, do not hold down the steam-shot button for more than
5 seconds.
For optimal steam burst, do not press the steam burst button more than three times in a row
to prevent the iron from cooling. Allow one minute of rest between each use.
Spray
- The spray function can be used with any temperature setting during the steam ironing or
dry ironing mode, as long as the tank is full.
- Press the steam button several times to moisten the garment.
Self-cleaning
1. Make sure that the device is switched off and the steam knob is in the 0 position.
2. Fill the water tank up to the maximum mark and close it.
3. Select the maximum temperature mode.
36
IRONHERO 3200 SMART ABSOLUTE
position according to your needs.
4. Plug the appliance into a power supply.
5. Unplug the appliance when it reaches the temperature.
6. Holding the iron horizontally over the tap, turn the steam knob to maximum, press the
auto-clean button and lightly shake the device. Place a container or bowl beneath the
iron.
7. The soleplate will emit boiling water and steam to remove all impurities.
8. Repeat this process if necessary.
9. After the self-cleaning process, switch on the device again and let the iron heat up to dry
the soleplate.
10. Switch off the iron when it has reached the selected temperature, slide the hot iron over a
piece of used cloth to remove any traces of water from the soleplate, and allow it to cool
down before storing it.
Recommendation
Carry out the self-cleaning cycle once every 2 weeks. When excessive limescale is observed,
carry it out more frequently.
Automatic shut-off function
The iron will automatically turn off when it is placed and kept still horizontally for 30 seconds,
or vertically for 8 minutes.
Note
Synthetic fabric, nylon, synthetic silk, and silk cannot be ironed with a steam iron, as this may
damage the surface finish.
Steam burst
By pressing the steam-shot button, the soleplate will shoot out a shot of steam. This function
can only be activated during high temperature ironing.
4. CLEANING AND MAINTENANCE
- Turn off, unplug the appliance from the power supply, empty the water tank (do it after
each use) and allow it to cool down completely.
- In case fabric is adhered to the soleplate due to heat, use a damp cloth and vinegar to
detach it.
- Do not use abrasive cleaners or scouring pads to clean the device.
- If scale blocks the steam outlet, use a toothpick to remove it.
- To protect the soleplate while it is stored, place the steam iron in an upright position on
its heel rest.
ENGLISH
37
IRONHERO 3200 SMART ABSOLUTE