cecotec IRONHERO 3200 SMART ABSOLUTE Manual De Instrucciones página 20

ENGLISH
Exterior iron surface
After unplugging and letting the iron cool down, wipe its exterior surface with a damp cloth
and, if necessary, a mild detergent.
Warning
Do not use any abrasive cleaning agent.
Soleplate
Starch and other types of residues can be easily removed from the soleplate with a damp
cloth. Do not use nickel balls to clean the soleplate or place the iron on rough surfaces to
avoid scratching the soleplate finish. If synthetic fabrics are ironed at high temperature, both
the fabric and the soleplate of the iron could be damaged. The best way to remove synthetic
residue from the soleplate is to heat it up and iron over an old cotton rag.
Warning
Do not use steam iron cleaners in this iron since they could damage its parts.
Storage
- Disconnect the iron from the mains supply.
- Empty the tank by turning the iron upside down and gently shaking it.
- Allow the iron to cool down completely.
- Wind the power cord around the base of the iron.
- Store the iron in a vertical position.
5. TROUBLESHOOTING
Problem Possible cause
Not enough or too much The temperature knob is not
heat in the right position, or the
appliance is switched off.
No steam or leakage The temperature knob is set
to the minimum position.
The steam-shot function The steam-shot function has
or vertical ironing does been used too often within a
not work properly very short period. The iron is
not hot enough.
38
IRONHERO 3200 SMART ABSOLUTE
Solution
Turn the temperature knob to
the appropriate position.
Continue ironing in horizontal
position and wait a few
minutes before using the
vertical steam burst function
again.
The iron's soleplate leaks The temperature knob has been set to the "MIN." position.
Set the temperature knob and steam selector to the correct
position.
The iron is not hot enough.
Water is over the Max mark.
Little steam Steam holes are blocked.
Little or no water in tank.
Spray does not work Not enough pressure or air
properly inside.
Fig.3
6. TECHNICAL SPECIFICATIONS
Product reference: 01873
Product: IronHero 3200 Smart Absolute
Rated voltage: 220-240 V~
Frequency: 50-60 Hz
Power: 3200 W
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities.
Consumers must contact their local authorities or retailer for information concerning the
correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
ENGLISH
Wait until the red-light
indicator turns red.
Empty the remaining water.
Clean the openings with
distilled water.
Add water to tank.
Press the spray nozzle
manually and press the spray
button several times in a row.
39
IRONHERO 3200 SMART ABSOLUTE