Publicidad
Idiomas disponibles
Idiomas disponibles
If the inlet and drain hoses are screwed on and secured.
-
All packaging and printed material must be removed from the dishwasher.
-
Attention
-
After installation, keep this manual. The content of this manual is very useful for users.
-
Then, before using the dishwasher for the first time
Set the water softener.
-
Fill the water softener tank with approximately 500 mI of water (depending on the model)
-
and add dishwashing salt.
Refill the rinse aid dispenser.
-
Refill the detergent.
-
1. Setting the water softener
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance. The higher the
content of these minerals and salts, the harder the water is. The softener should be adjusted
according to the hardness of the water in your area. Your local water supply company can
advise you on the water hardness in your area.
Settings
The amount of salt dispensed can be set from H0 to H7. Salt is not required in the set
-
value H0.
Find out about the hardness value of your tap water. Your water supply company will help
-
you with this.
The pre-set value can be found in the water hardness table.
-
Close the door.
-
Press the power icon.
-
Press and hold the Delay icon and then press the Programme icon for 5 seconds.
-
The appliance beeps and H flashes on the display (the factory setting is H4).
-
To change settings
Press the Delay icon.
-
Each time the icon is pressed, the set value increases by one level. When the H7 level is
-
reached, the display goes back to H0 (off).
Press the Programme icon. The chosen setting is now saved.
-
Contact your water supplier company for information on the hardness of the water
-
supplied.
Every cycle with a regeneration operation consumes additional 2.0 litres of water; the
-
energy consumption increases by 0.001 kWh.
BOLERO AGUAZERO 6100E/ INOX E/ DARK E
ENGLISH
77
Publicidad
