cecotec BOLERO AGUAZERO 6100 E Manual De Instrucciones página 90

ENGLISH
Push the baskets back inside. It is recommended to load the lower basket first and then
-
the upper basket (see section "Loading the dishwasher"). Pour in the detergent (see
section "Salt, detergent and rinse aid").
Plug the power cord into the outlet. The power supply is 220-240 V AC 50 Hz, the socket
-
specification is 12 A 250 VAC. 50 Hz.
Make sure the water supply is on and it has the maximum pressure. Close the door, press
-
the power icon. Press the programme icon to select the desired wash cycle (see section
"Washing cycle table"). Close the door to ensure that it is completely closed.
NOTE: a "click" is heard when the door closes perfectly.
When the wash cycle finishes, you can switch off the appliance by pressing the power icon.
Switching on the dishwasher
1. Open the door if it is closed.
2. Close the door.
3. Make sure that the dishes do not obstruct the spray arms.
4. Switch on the dishwasher by pressing the power icon.
Selecting a programme
Choose a programme according to the type of load and its degree of soiling.
The different programmes and their uses are described in the washing cycle table in this
manual. Use the programme icon to select the desired wash cycle.
Changing the programme
An ongoing cycle can only be modified if it has been running for a short time. Otherwise,
-
the detergent may have already been released and the machine has already drained the
wash water. In this case, the detergent dispenser must be refilled (see section "Refilling
detergent").
Press the power icon to cancel the programme and then switch on the appliance again.
-
You can change the programme to the desired cycle setting (see section "Starting a wash
cycle").
NOTE (depending on the model):
if you open the door during a wash cycle, the appliance stops and the warning alarm
-
sounds, then the display shows E1. After closing the door, the appliance will continue to
operate after 10 seconds.
The 6 programme lights show the status of the dishwasher:
-
One of the programmes lights on--> cycle running.
-
One of the programme lights flashing --> pause.
-
NOTE: if all lights start flashing, indicating that the machine is malfunctioning, disconnect
-
BOLERO AGUAZERO 6100E/ INOX E/ DARK E
90