Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
2. Coarse filter
Large debris, such as bones and glass, which could clog the drain, will be trapped in the
-
coarse filter.
To remove an object caught in this filter, gently squeeze the tabs above this filter and lift
-
it out.
3. Microfilter
This filter retains dirt and food debris in the drain area and prevents it from being
-
deposited back into the dishes during a cycle.
Check the filters for blockages every time the dishwasher is used.
-
The filter system can be removed by unscrewing the coarse filter. Remove food debris
-
and clean the filters under running water.
Step 1: counterrotate the coarse filter and then lift it up. (Fig. 19)
-
Step 2: lift the flat filter (Fig. 20)
-
NOTE: if executed from step 1 to step 2, the filtering system shall be removed; if executed
from step 2 to step 1, the filtering system shall be installed.
Filter assembly
For best performance and results, it is necessary to clean the filter assembly. The filter
-
effectively removes food particles from the wash water, allowing it to recirculate during
the cycle. For this reason, it is advisable to remove larger food particles trapped in the
filter after each wash cycle.
Rinse the semi-circular filter under the tap.
-
To remove the filter assembly, pull the handle of the container upwards.
-
The filter assembly should be cleaned once a week.
-
To clean the coarse filter and the microfilter, use a soft cleaning brush.
-
Then, reassemble the filter parts as shown in the previous figures and put the whole
-
assembly back into the dishwasher.
Put the filter assembly in place and press down. Never use the dishwasher without the
-
filters installed.
Incorrect substitution of the filter may reduce the performance level of the device and
-
damage the tableware and utensils.
WARNING!
Never use the dishwasher without the filters installed. When cleaning the filters, do not knock
them. Otherwise, the performance of the dishwasher may be deformed and degraded.
Cleaning the spray arms
The arms accumulate chemical products, so it is necessary to clean the spray arms regularly,
as the chemicals in the hard water clog the spray arm jets and bearings. To remove the spray
BOLERO AGUAZERO 6100E/ INOX E/ DARK E
92
Publicidad
