Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
There is foam
inside the
dishwasher
The interior is
stained
Dishes and
cutlery are not
clean
There are
stains and
layers of dirt
on glasses and
cutlery
BOLERO AGUAZERO 6100 FULL-BI E
100
Unsuitable
detergent
Spilled rinse aid
Detergent with
colouring agent
was used
Incorrect
programme
Incorrect basket
loading
1. Very hard
water
2. Low inlet
temperature
3. Dishwasher
overloading
4. Inadequate
loading.
Out-of-
date or wet
detergent
powder.
5. Empty rinse
aid dispenser
6. Incorrect
detergent
dosage
Use only detergent special for dishwashers to prevent
foam formation. If there is foam forming, open the
dishwasher and let it evaporate. Add 4 litres of cold
water inside. Close and lock the dishwasher, then
start the pre-rinse wash cycle to drain the water.
Repeat the process if necessary.
Always clean spilled rinse aid immediately.
Be sure to use dye-free detergents.
Select a more powerful programme.
Make sure that the detergent dispenser and spray
arms are not blocked by large dishes.
To remove stains from glassware
Remove all metal utensils from the dishwasher.
-
Do not add detergent.
Choose the longest cycle.
-
Start the dishwasher and let it run for 18 to 22
-
minutes. The main wash should then be carried
out.
Open the door to pour 2 cups of white vinegar into
-
the bottom of the dishwasher.
Close the door and let the dishwasher finish the
-
cycle. If vinegar does not work repeat the above
procedure but use 1/4 cup (60 ml) citric acid
instead of vinegar.
Publicidad
