cecotec BOLERO AGUAZERO 6100 FULL-BI E Manual De Instrucciones página 97

To fix the panel, follow the instructions in figure 26.
Fig. 26 key:
1.- "T" shaped connector
2.- Install in the direction of the arrow
3.- Remove 4-ST4x12 screws and replace with 4-ST 4x42 wood screws.
4.- Decorative panel (3-7 kg)
5.- Dishwasher door
6.- Decorative panel
7.- 2-4x26 wood screws
8.- 4-4x42 wood screws
8.3 Setting the spring tension on the door
After fitting the panel, try opening and closing the door to check the balance and whether the
door can remain in the same place without imbalance. If not, you can adjust it by using a CR-V
4 mm Phillips screwdriver and adjusting the sides of the door as shown in figure 27. La puerta
debe estar equilibrada entre 30 y 90°.
8.4 Installation of the skirting board (baseboard)
Figure 28
1.- Decorative panel
2.- Skirting board
NOTE: the following table shows the different skirting boards heights required, depending on
the needs in terms of aesthetics and door opening and closing.
OPTION
1
2
3
4
5
6
Choose an option and follow the indicated measurements to ensure that the door can be
opened and closed without difficulty and that there is no gap between the decorative panel
and the skirting board.
HEIGHT OF
DECORATIVE THE SKIRTING
PANEL (mm)
708
698
688
678
668
658
HEIGHT OF
BOARD (mm)
75
85
95
105
115
125
BOLERO AGUAZERO 6100 FULL-BI E
ENGLISH
97