cecotec BOLERO AGUAZERO 6100 FULL-BI E Manual De Instrucciones página 81

(Fig. 4).
If this is the first time you refill the container, fill 2/3 of its volume with water (around 500
-
ml). (Fig. 5)
Place the end of the funnel into the hole and introduce about 2.0 kg of dishwasher salt
-
(the quantity may vary depending on the model). It is normal for a small amount of water
to come out of the salt compartment.
Carefully screw the cap back on.
-
Normally, the salt warning light will be off in 2-6 days after the salt container has been
-
filled.
NOTES:
You must only refill the salt container when the salt indicator light lights up on the control
-
panel. Even if the salt container is sufficiently full, the indicator light may not go out
before the salt is completely dissolved. If the salt indicator light on the control panel does
not light up (in some models), you can estimate when to fill the salt in the descaler by the
cycles the dishwasher has run.
If there are salt spills, a soaking programme can be run to remove them.
-
WARNING: if you do not add salt, the cleaning effect on the dishes will be poor and limescale
will be produced.
3. Refilling the rinse aid dispenser
Rinse aid function
The rinse aid is automatically added during the last rinse. It ensures a thorough rinsing and a
spot free drying.
Warning!
Only use rinse aids for dishwashers. Never refill the rinse aid dispenser with other substances
(e.g., dishwasher detergent, liquid detergent). This may damage the appliance.
When to refill the rinse aid dispenser
Unless the rinse aid warning light on the control panel is on, you can always estimate the
amount from the colour of the optical level indicator "D" next to the cap. When the rinse aid
dispenser is full, the indicator will be fully lit. As the rinse aid diminishes, the light fades too.
Never allow the rinse aid level to be below ¼ of its capacity.
The size of the light changes on the rinse aid indicator as the rinse aid decreases.
BOLERO AGUAZERO 6100 FULL-BI E
ENGLISH
81