cecotec BOLERO AGUAZERO 6100 FULL-BI E Manual De Instrucciones página 99

If an overflow occurs, turn off the main water supply before calling the official Cecotec
Technical Support Service. If there is water in the base due to overfilling or a small leak, the
water must be removed before restarting the dishwasher.
Before calling technical support service
The following tables may save you from having to contact technical support.
Problem
The
dishwasher
does not work
Drainage pump
does not stop
Noise
Possible causes
Fuse has blown
or circuit breaker
has been tripped
The power
supply is not on
Water pressure
is too low
Overflow
Some sounds are
normal
Utensils are
not secure in
the baskets or
something small
has fallen out of
a basket.
Engine humming
Possible solution
Replace the fuse or reset the circuit breaker in the
main switchboard of your home. Remove any other
device sharing the same circuit as the dishwasher.
Make sure the dishwasher is on and door is properly
closed. Make sure that the power cord is plugged into
the socket properly.
Check that the water supply is connected properly and
that the water is turned on.
The system is designed to detect an overflow. When it
detects this, it switches off the circulation pump and
switches on the drain pump.
Sound of detergent dispenser opening.
Make sure that everything is securely fastened in the
dishwasher.
The dishwasher has not been used regularly. If you
do not use it often, remember to schedule it to fill and
empty every week, which will help keep the gasket
moist.
BOLERO AGUAZERO 6100 FULL-BI E
ENGLISH
99