Publicidad
Idiomas disponibles
Idiomas disponibles
14. CLEANING THE FILTER
Clean the WAVE 200 XL filter after every cleaning cycle as follows:
1. Press the latch on the top of the WAVE 200 XL to open the top cover.
2. Remove the filter chamber from the robot and separate its parts
(cyclone spiral and fine filter cartridge).
3. Wash the fine filter cartridge with water pressure from the inside out.
4. Wash the cyclone spiral from the inside out and the chamber.
5. Return all of the filter parts to the filter chamber and put the chamber back in the WAVE 200 XL.
6. The robot is ready for a new cleaning cycle.
Cyclone spiral
Filter chamber
15. TROUBLESHOOTING
To save a log file to a USB memory stick if required by a technician, from the main Wave screen,
press on the green buttons in sequence – right-left-right-left and follow the instructions displayed
on the screen.
Error Message
Possible Cause
Is there dirt or other foreign
Imp overload
matter in the impeller?
Imp overload
Does the problem reoccur with
every operation?
Does the problem
Imp underload
reoccur with every operation?
Drive overload
Is there any interfering dirt in
the driving belts, brushes, or
drive axles?
WAVE 200 XL
User Instructions
|
Fine filter
Coarse filter
Action
Disconnect the robot from the mains
electricity, remove the screws and remove the
impeller cover.
Remove any dirt from around the impeller.
Reassemble the impeller cover.
Contact your Maytronics dealer.
Contact your Maytronics dealer.
Remove any dirt or foreign bodies that might
have become entangled with the driving
belts, brushes, or drive axles.
Cover open
latch
11
Publicidad
