Publicidad
Idiomas disponibles
Idiomas disponibles
Error Message
Possible Cause
Drive overload
Does the problem reoccur with
every operation?
Drive under
Does the problem
load
reoccur with every operation?
Is there an electrical short,
DC input
or a partial or complete
disconnection?
Robot is stuck
Has the robot stopped in
on wall
a vertical position of more
than 45º?
Is the robot stuck on an
obstacle?
Out of water
Was the robot operated out
of the water for an extended
time?
Is the robot stuck on an
Robot is stuck
obstacle?
Is there an obstruction in the
water channel or in the robot's
driving belts?
Navigation
Does the problem reoccur with
System
every operation?
Does the problem occur when
No
Communication
pressing POOL or HOME on
the MMI?
Over
Does the problem occur when
Current
pressing POOL or HOME on
the MMI?
12
Action
Contact your Maytronics dealer.
Contact your Maytronics dealer.
Contact your Maytronics dealer.
Move the robot from its position and remove
the obstacle. Reactivate.
If this reoccurs, contact your Maytronics
dealer.
Check that the impeller is in order and that its
blades are not broken.
Reactivate. If this reoccurs, contact your
Maytronics dealer.
Move the robot from its position and remove
the obstacle. Reactivate.
If this reoccurs, contact your Maytronics
dealer.
Contact your Maytronics dealer.
Contact your Maytronics dealer.
Step 1: Disconnect the floating cable from
the roller inner connection and connect
the cable direct to the power supply. If this
reoccurs - go to Step 2.
Step 2: You can work temporarily without
using the MMI.
Disconnect it from the power supply thus
disabling the Pool/Home function and use
the remote control.
Contact your Maytronics dealer.
Disconnect the floating cable from the roller
inner connection and connect the cable
directly to the power supply.
WAVE 200 XL
User Instructions
|
Publicidad
