Ferroli BLUEHELIX TECH RRT 30 H Instrucciones De Uso página 189

BLUEHELIX TECH RRT 30 H
Opening the front panel
Some internal components of the boiler can reach temperatures high
B
enough to cause severe burns.Before carrying out any operation, wait for
these components to cool or else wear suitable gloves.
To open the boiler casing:
1. Partially undo the screws A (see fig. 34).
2. Pull the panel B towards you and release it from the upper fastenings.
On this unit, the casing also acts as a sealed chamber. After any operation
B
involving opening the boiler, carefully check the correct refitting of the front
panel and its seal.
Proceed in reverse order to refit the front panel. Make sure it is correctly hooked to the upper fastenings and is correctly
positioned at the sides. When tightened, the head of screw "A" must not be below the lower fold (see fig. 35).
EN
A
A
A
fig. 34- Front panel opening
OK
fig. 35 - Correct position of front panel
cod. 3541C672 - Rev. 00 - 09/2020
B
NO
189