Oase Filtral UVC 1500 Puesta En Marcha página 15

Assembly
Operation with water feature
 A
When operating together with a water feature, the device should be set up horizontally.
(→ Set up the device horizontally)
The branch valve is mounted together with the nozzle pipe and nozzle insert at the device's out-
put.
• Depending on the nozzle insert used, a specific water feature is created.
Connection to the second output of the branch valve:
• Hose connection for a watercourse/water feature.
• Filtral 1500: Operation is possible either with the fountain or with the optionally available Ven-
turi nozzle.
• Filtral 3000/6000/9000: When using the Venturi nozzle, run the air hose along the nozzle
pipe and secure in the holder on the nozzle connection. The air hose must be able to suck in
air, no water may be allowed to enter the air hose.
Hand-tighten the bolt connections.
Operation without water feature
 B
When operating without a water feature, the device can be set up either horizontally or hung up.
(→ Set up the device horizontally)
(→ Hang up the device)
Connection to the output of Filtral 1500:
• Use a branch valve in order to connect up the hose for a watercourse/water feature.
• Connection for a Venturi nozzle (optionally available, 70364).
• Do not connect anything to the output.
Connection to the output of Filtral 3000/6000/9000:
• Connecting up the Venturi nozzle provided with scope of delivery (possible with and without a
branch valve).
• Hose connection for a watercourse/water feature (possible with and without a branch valve).
• Do not connect anything to the output.
Hand-tighten the bolt connections.
EN
15