Publicidad
Idiomas disponibles
Idiomas disponibles
3. Hold the product from one side, note the position of the hole on the back cover, and slide it
into the slot. Wall installation is finished, as shown in the illustration below.
Show temperature
Wi-Fi/Light Button
Mode button
Left button
• Plug the heater into the power outlet, it will beep when turned on. The heater will go into
standby mode, displaying the icon
• To start heating, press the button
device is in "ECO" mode status.
• The "ECO" mode is the average power, the "Comfort" mode
• To change the heating mode, press the "MODE" button
"ECO" mode
,"Comfort" mode
lected mode, it will begin to heat up and the "Heating" icon
• Use the "Left/Right" buttons
range is from 5°C to 50°C.
NOTE: Please note that the temperature displayed on the screen is the ambient tempera-
ture. The temperature you set the heater to is displayed when you press the keys
• To set the timer, press the button
digits will flash after setting and then the display will return to heating mode. The timer
icon will be displayed on the screen when the timer has been set. The heater will turn off
automatically when the set time elapses.
• To set the child lock, press and hold the button
on the screen, then the control panel will be locked. To unlock, press and hold the
button
(left) . The padlock icon will disappear and all buttons can be used again.
HEATER CONTROL PANEL
or timer setting
Y
. You will see the "ECO" mode icon
and "Antifreeze" mode
to adjust the temperature in any way. The temperature
"Timer" (The timer range is from 1 to 24 hours.) The
Temperature indicator
Timer indicator
Safety lock indicator
.
to cycle through the modes:
. When the heater is in the se-
it will light up.
(right) until the padlock icon appears
min.
15cm
Button on/off
Timer button
Right button
. This means the
is the maximum power.
E NGLI SH
.
9
Publicidad
